Aluminum Framed Decon Shower 11'L x 12'W x 8.25'H
The DATAL 1514S is a 2-Line, 3 or 4 stage, Mass Casualty Decon Shower System. Undress/Detergent Shower/Rinse Shower/Redress configuration. Decon 2 to 4 ambulatory personnel, 2 non-ambulatory or any combination at one time.
All parts are pre-assembled w/ no special tools required. Frame system is made of interconnected aluminum tubes that fold out in a scissor type movement. To ‘Quick Erect’- place the floor cover in the designated area and then place the closed/folded up DAT® AL™ series unit in the center of the floor cover. With 2-4 support personnel (size of unit dependent) have personnel grip each corner. Pull the width support frames slowly until unit is fully open and fits floor cover exactly. Then from underneath - lift the center of the tent upwards until the two sides reach the ground almost perpendicular to one another. Clip the buckles together at the four corners (inside of the frame) while supporting the center of the tent in the air. Check/final position canopy and affix floor with HD velcro attachments. Commence use.
- Air Inflation Valve
- Inflation Hose
- Pressure Relief Valve
- Tie down ropes
- Repair Kit
- Shelter sleeve
- Air vents
- Roll Up Windows
- Air Ducts
||11’ W x 12’ L x 8.25’ H - 132 ft2
||48" L x 48" W x 58" H
||ANSI 113 compliant
||- Heavy duty 100% nylon twill (3/5) w/ PU white pigment inner coating
- UV/chemical resistant/fire retardant
– UV resistant and water repellent w/ a hydrostatic resistance of 250 psi +
- Mildew resistant to meet and exceed US Fed. Test MIL.STD.810E 508
- Fire resistance meets and exceeds CPAI 84 SECTION 5 1995
- US Fed. Test CFR.1610
- meets NFPA701 Flammability Test method 1 (2004)
- NFPA 702 w. ‘A’ burn scale rating
||Approx. 23mm X 57/58
||Approx. 1.230 gr/m2
||100% Nylon 210T Antron Water Resistant, Polyurethane Coated 57/58"
Flame Retardant to meet 'NFPA-701 TM-1'
||1,000 denier Nylon coated w/ PU
||Retractable, corrosion resistant, 16mm HD aluminum tubing w/ 1.5mm wall thickness tubing shelter w/ high density polyfiber hub
|Length per section:
|Minimum Tear Strength:
||Approx. 55 mph
||Approx. 2,200 lbs. – 20 + lbs/ft2