Halogenated Hydrocarbons Detection Tubes 100/a (200 - 2,800 ppm)
For short-term measurements more than 160 Draeger-Tubes are available to measure the spot concentrations of specific gases. Measurement usually takes between 4 seconds and 15 minutes. The tubes are used either manually with the Draeger-Tube Accuro Pump or automatically with the Draeger X-act 5000.
A wide range of different gases and vapors can be detected and measured, such as:
- Determining and measuring concentration peaks
- Measuring personal exposure in the inhalation area
- Detecting leaks in pipelines, gas installations etc.
- Air analysis in sewers, shafts and confined spaces
Please Note: This is a Haz-Mat product and must be shipped Haz-mat Freight. Extra shipping fees will apply.
Halogenated Hydrocarbons Detection Tubes 100/a (200 - 2,800 ppm)
| Standard Measuring Range: |
200 to 2,600 ppm R 113/R 114
100 to 1,400 ppm R 11
The indication is in mm and must be compared to the calibration data sheets. |
| Number of Strokes (n): |
3 |
| Time for Measurement: |
approx. 1 min |
| Standard Deviation: |
±30 % |
| Color Change: |
blue ?> yellow to grayish green |
| Temperature: |
0 to 40° C |
| Absolute Humidity: |
1 to 15 mg H2O / L |
| Reaction Principle: |
a) R113 [pyrolysis] ??> HCl
b) HCl + pH Indicator ??> yellow reaction product |
| Cross Sensitivity: |
Other halogenated hydrocarbons, free halogens and hydrogens halides are also indicated, however, with differing sensitivity. Perchloroethylene is indicated with the same sensitivity as R113. |
| Additional Information: |
The tubes become very warm during the measurement. Therefore, these tubes should not be used in potentially combustible atmospheres. A combustible gas monitor should be used to qualify any questionable area before conducting a measurement with one of these tubes. |
Halogenated Hydrocarbons Detection Tubes 100/a (200 - 2,800 ppm)
There are no reviews yet.